Allwin Sensor Reservoir Heater

Key features

• Temperature sensor probe for reservoir/sub-tank heater

• Factory-calibrated; includes spec card (per OEM)

• Pre-terminated harness for plug-and-play replacement

• Ensures accurate temperature feedback and consistent heating

• Drop-in fit on models that specify this part number

Specifications

• Type: Thermistor-type temperature sensor (per OEM spec)

• Application: Reservoir/Sub-tank heater feedback

• Leads/connector: OEM harness and connector (match to original)

• Operating range: Suitable for heater control range of Allwin units

• Condition: New replacement part

Compatibility

• For Allwin printers that list as the reservoir heater sensor.

• Typically used with the sub-tank heater control board and strip heater assemblies. Confirm in your service manual.

What’s in the box

• (1) Reservoir heater sensor probe with cable and connector

Install notes

• Power off and unplug the printer before servicing.

• Observe ESD care and route the cable as per OEM clips/guides.

• Connect to the designated SENSOR/THERM port on the heater board.

• After installation, run a temperature test to confirm stable readings.